Electronics install help please…

[Craig]

I could use some help installing the electronics in my plane. Is there an order to the 3 wires coming off the motor? With the esc, Im guessing the connector with the red, black and white wire will go into the battery slot of the receiver, but where does the yellow plug go? I have a spektrum AR410. Im ready to fly this but I dont want to fry anything. Any help is appreciated. I will attach a photo.

[KevinC]

You are correct that the red/white/black wired plug goes to the battery slot on the receiver. I'm pretty sure the yellow wire is for thrust reversing (used on certain "3d" planes only), which you will not need on a Papillon. As for the motor wires, mount everything on the plane and hook them up. Bind the receiver per your radio's instructions and then give it a little throttle. If it blows aft, you're good to go. If it blows forward, swap any two of the three motor wires. It's an elegantly simple system with brushless motors.